Navan headlights, rear lights and blinkers combine safety and reliability, with a modern design, thanks to the use of LEDs and sequential turn signals. You have to hack trough epoxy glue that holds the lens and that is material that was designed to be as thought as possible. Undergo rigorous testing to ensure exceptional resistance to the elements and provide reliable service regardless of the weather conditions. Once you’ve pulled the old headlamp assembly away from the vehicle a short distance, it’s time to get a full look at wiring harnesses that are attached.

Wide-ranging upgrades have strengthened the appeal of the Lexus UX 300e, the urban crossover launched three years ago as Lexus’s first all-electric model. First, vents along the top and bottom of the headlight housing are necessary to equalize pressure differences that would otherwise cause the entire assembly to crack and fail. For any new part, headlights, or otherwise, it’s always a “best practice” to start by unpacking the components and verifying that everything is in good shape. The first half of the production period (before the manufacturer updates the chassis) is commonly referred as Pre-Facelift, whereas post half of the chassis production period is referred as Facelift.When you are facing the same way as the car is facing, the steering wheel is on the left/right side, that means your car is the left/right hand drive. You will need to remove the signal bulb from the old lamp (do NOT disconnect any wires) and install it, in its existing housing, into the new lamp. Usually, either a simple squeeze on the edges of the connector or pulling up on a tab is enough to cause the connector to release its grip, but if a thin wire bar is present, it usually needs to be slid into an unlocked position first.

Our factory has American DOT, European E-Mark, and Chinese CCC certification to assure product quality. they are plug n play, the outer two lenses are the low beams and those work just fine but the high beams aren’t really good, the lens is narrow. I trust your judgement, since you have used them on a 2010 model IS 250, just wanted to be sure that they'll work if I disable the auto leveling feature. Lexus car owners with GS models from 1993 to 1997 can find sellers with IS 250 headlights compatible with the car.

Headlight comes with Projector Headlights which provides the maximum beam output while increasing your visibility.

In short - if they are not cracked then simply polish them, or if they are really really bad, then you can as well replace them altogether.If you did this, you’d need to find a good place to zip tie, 3m dual sided tape, or some way to secure the ballast to the car somewhere to minimize movement and potentially disconnecting.